I needed 3 yards of top soil and that's what I got! Right on time and right where I asked it to be placed (Order# 2041).

How It Works
Getting started is easy — just follow these simple steps
Choose your quantity
Adjust the quantity to match your project. One cubic yard covers about 100 to 160 square feet at a 2 to 3 inch depth.
Select your delivery date
Select a delivery date you'd like for the product to be dropped off at your home
Sit back and wait
Sit back, wait, and let us work our magic to make sure the highest quality product is delivered to your driveway.
We had a great experience with mulch mound! Our mulch arrived when we requested. The delivery fee was so reasonable. We’ll use them again for sure!
Complete Your Outdoor Project
Mason sand pairs with paver base stone underneath and polymeric jointing sand on top for a finished patio or walkway. If you are mixing mortar for brick repair on one of Owensboro's older homes, you will also want portland cement and lime on hand. Some builders are shifting to clean chip stone for paver bedding instead of sand since it does not pump under pressure, worth asking about if drainage is a concern on your site.
Service area
Areas we deliver sand in Owensboro, Kentucky
Owensboro's silt loam holds water longer than sandy soil, so if you are setting pavers, make sure your base compacts fully before adding jointing sand on top. Skipping compaction here causes more settling than in sandier regions because the subsoil beneath your base stays soft longer after rain. Test compaction with a hand tamper before you spread any sand, and give the site a dry day or two if recent rain has soaked the ground.
A common mistake is using mason sand for paver bedding instead of joints. It is too fine for a load bearing base and it shifts under vehicle weight or heavy foot traffic over time. Many contractors are moving to angular chip stone for the bedding layer specifically because it locks together and does not pump moisture up through the joints the way sand can during freeze thaw cycles.
If you are mixing mortar for brick or block repair, buy your sand and cement close together in timing since bagged cement can absorb humidity and clump if it sits too long in Owensboro's humid summers. Order enough sand for the whole job in one delivery, since color and grain consistency can vary slightly between separate loads and that shows in a finished mortar joint.
Working With Sand in Owensboro
Owensboro sits on silt loam soil that holds moisture and can get greasy when wet, which is exactly why mason sand matters for hardscape work here. Contractors setting pavers around town use it in the joints because it compacts tighter and resists washout better than the native soil alone. With frost reaching down through April 10 and starting back up by late October, anything you set in sand needs a stable base before winter movement sets in. It also shows up in mortar mixes for the brick and block work common on older Owensboro homes near downtown.
Masonry vs Fill Sand
Masonry sand is washed and finely screened, the right choice for mortar work, paver joints, and sandboxes. Fill sand is coarser and less processed, better suited to leveling, bedding pipe, and filling low spots.
Bedding and Leveling
For pavers, screed a 1 inch sand bed over a compacted base rather than using sand to fix deep grade problems. A thin, even bed locks pavers in place. A thick one shifts underfoot.
Working With Moisture
Slightly damp sand spreads, screeds, and compacts far more easily than bone dry sand, which just flows back into your screed lines. Lightly wetting the pile before you work it saves real effort.